During the cleaning operation with CLEAN SOL, is it suggested to cover the solar panels?
Yes, it is. We suggest to cover the solar plant and the water temperature must be lower than 40°C.
Where can I use CLEAN F STEEL?
CLEAN F STEEL is developed to clean stainless steel heat exchangers.
How can I use CLEAN F9 A and CLEAN F9 B?
To remove the majority of incrustations in the fume side of heat exchanger you should: Spray CLEAN F9 A Let the product react from 10 – 20 minutes. Brush and thoroughly rinse the whole surface with mains water Spray CLEAN F9 B Let the product react from 5 – 15 minutes. Brush and thoroughly rinse…
Where can I use CLEAN F9 A and CLEAN F9 B?
CLEAN F9 A and CLEAN F9 B is developed to clean the fume side for aluminium heat exchangers / combustion chambers.
Does CLEAN BOILER damage plastic components?
No, if correctly used (it must circulate from 2 to 8 hours) CLEAN BOILER does not damage any plastic nor metal component. It is a salinized product which reacts only with metal oxides.
Which is the CLEAN BOILER function?
CLEAN BOILER removes metal oxides incrustations and scales from the water side of the boiler (primary heat exchanger, 3 way valve, circulating pump, etc.). It restores the correct heat exchange, avoid boiler damages and maximizes system and boiler efficiency.
T-MAG magnetic filters block also non-magnetic debris?
Yes, T-MAG magnetic filters block also all non-magnetic debris thank to its filtering basket with 450 micron mesh. It guarantee a total protection of your boiler.
Which is the T-MAG filter function?
T-MAG magnetic filters block and remove all iron oxides and non-magnetic debris (aluminium scales, etc.) inside the heating system. We suggest to install a T-MAG filter also in a heating system without an high quantity of iron oxides in order to avoid primary heat exchanger and circulating pump damages.
Which is the BIOCID function?
BIOCID removes and prevents biomasses and bacterial colonies from underfloor heating system, it reacts directly against bacterial colonies which proliferate in a low temperature/underfloor heating systems causing incrustations and circulation problems. It must be used in underfloor heating system during the first system loading as inhibitor with PROTECT 1. Otherwise during the powerflushing procedure with…
Which is the correct dosage of the CLEAN 10?
CLEAN 10 must be dosed from 7 to 10%, you can check the correct dosage by using the CONDUCTIMETER. With 7% dosage the conductivity must be 5.000 micro/s; with 10% dosage the conductivity must be 7.000 micro/s. After the rinsing operation the system conductivity must be the same of main’s water.
